Click Home > 2D Plot and select 2D View at the bottom of the graphics model to view the 2D View of the graphic output. This section describes the 2D view options and the graphics produced for subsequent printing or capturing.
The software disables the 2D Plot panel in the following situations:
-
You must run the analysis on the job before you can view the graphics output.
-
You must select 2D View for the graphics output below the model.
The available 2D graphic plots are:
-
A general tank sketch showing plate layouts and overall dimensions
-
A pair of nozzle interaction diagrams, used to check the conformance of the nozzle to API-650 Appendix P
-
A sketch of the results of the supported cone roof design
-
A plot of the shell settlement and optimum cosine curve results
Each of these graphic plots is discussed in the sections that follow.
You can view and save output in 3D view by clicking 3D View at the bottom of the graphics model.