The following Insulation attributes are used only if the Insulation View is set to a value of either 2 or 3:
Attributes |
Description |
Implementation Details |
---|---|---|
IJUAhs_InsulationTh:: |
Total thickness of the Insulation. |
Default units are specified on the CustomInterfaces sheet. Specify the units otherwise. IE: |
IJUAhs_InsulationThRl:: |
An HgrSupportRule that returns a numerical value for InsulationThickness. The Hanger Rule should be present in the catalog; it can be a rule Name or ProgID. If you intend to use InsulationThickness to directly specify the thickness, then this attribute should be left blank. |
IE: Rule Name: Rule ProgID: |
IJUAhs_InsulationThSel:: |
Determine which attribute is used to set InsulationThickness. If no value is given, the InsulationThickness attribute will be used by default. If the shoe is being used as a sub assembly, check to see if the Length3 attribute has been set by the parent assembly |
hsSelection 1 = By Rule 2 = By Input |
IJUAhs_InsulationThDef:: |
The definition of the InsulationThickness value. This attributes specifies how the attachment should be measured. If a value is set for InsulationThickness but no definition is given, an error will occur. |
1 = Insulation Thickness (direct) 2 = Pipe Insulation Thickness + InsulationThickness |
IJUAhs_InsulationL:: |
Total Length of the Insulation. |
Default units are specified on the CustomInterfaces sheet. Specify the units otherwise. IE: |
IJUAhs_InsulationLRl:: |
An HgrSupportRule that returns a numerical value for InsulationLength. The Hanger Rule should be present in the catalog; it can be a rule Name or ProgID. If you intend to use InsulationLength to directly specify the length, then this attribute should be left blank. |
IE: Rule Name: Rule ProgID: |
IJUAhs_InsulationLSel:: |
Determine which attribute is used to set InsulationLength. If no value is given, the InsulationLength attribute will be used by default. |
hsSelection 1 = By Rule 2 = By Input |
IJUAhs_InsulationLDef:: |
The definition of the InsulationLength value. This attributes specifies how the attachment should be measured. If a value is set for InsulationLength but no definition is given, an error will occur. |
1 = From Bottom of Insulation |