Description |
This section describes the Rod Hanger assembly and the associated attributes. |
|
Support Sheets |
DDS_CS_<…> DDS_RR_<…> DDS_VS_<…> |
|
Sub-Assembly Sheets |
DDS_RH_TOP DDS_RH_BOT DDS_TRAP_BOT DDS_RISER_BOT |
DDS_VS_Middle DDS_CS_Middle DDS_AxLatData |
ProgID |
DataDrivenSupports,Ingr.SP3D.Content.Support.Rules.CSHanger DataDrivenSupports,Ingr.SP3D.Content.Support.Rules.CSRiser DataDrivenSupports,Ingr.SP3D.Content.Support.Rules.CSTrapeze DataDrivenSupports,Ingr.SP3D.Content.Support.Rules.RRHanger DataDrivenSupports,Ingr.SP3D.Content.Support.Rules.RRRiser DataDrivenSupports,Ingr.SP3D.Content.Support.Rules.RRTrap DataDrivenSupports,Ingr.SP3D.Content.Support.Rules.VSHanger DataDrivenSupports,Ingr.SP3D.Content.Support.Rules.VSRiser DataDrivenSupports,Ingr.SP3D.Content.Support.Rules.VSTrapeze |
The Rod Hanger Supports are designed as super-assemblies that contain several sub-assemblies. This design allows you to make many rod hanger support configuration types with minimum effort. You can create supports with different combinations of top structure and bottom route attachments by using the sub-assemblies described in the Top, Middle, or Bottom sub-assembly sheets. The following graphic illustrates the way in which you can create Rod Hangers with sub-assemblies.
Super: [VS_Single] |
[VS_Riser] |
[VS_Trapeze] |
---|---|---|
Top: [RH_TOP] |
Top: [RH_TOP] |
Top: [RH_TOP] |
Middle: [VS_Middle] |
Middle: [VS_Middle] |
Middle: [VS_Middle] |
Bottom: [RH_BOT] |
Bottom: [RISER_BOT] |
Bottom: [TRAP_BOT] |