-
Click Seam by Projection Command to display the Seam By Projection Ribbon.
-
Select the plate system for the seam.
-
Define the landing curve using one of the following methods:
-
Click Boundaries .
-
Define the seam boundaries using one or more of the following methods. If you do not select boundaries, the software applies the entire length of the base curve to the resulting seam curves.
-
Click Accept .
-
Select if you are placing a design seam or a planning seam.
-
If the boundary definition results in two solutions, pick the needed solution using the following procedure:
-
Click Finish to place the seam.