-
In the Domain Explorer, expand the Panels by Category > Junction Boxes hierarchy and then select junction box 101-JB-DCS-001.
-
Right-click the selected junction box and then on the shortcut menu, click
Actions > Connection. -
Make sure that terminal strip 101-JB-DCS-001, TS-1 is selected in the Terminal strip list (there is only one terminal strip on the list).
-
In the Cables folder of Domain Explorer, select cable C-101-LT-201 and drag it to the right side of terminal 6.
-
On the Cable Connection Definition dialog box, make your selections as follows:
-
Under Cable end to connect, select End 2.
-
Select the connection type as 3 in a row and select the cable set in the right data window.
-
-
Click Connect to make the connection.
-
After the cable has been connected, open the Point-to-Point Wiring Diagram for the wire connected to terminal 6+ and view the connection. It should go straight to terminal strip FT-1 of the marshaling rack.
-
Print out the Point-to-Point Wiring Diagram if needed and then click X to close it.
-
Click X to close the Connection window.
-
Now select 101-DCS-001 from the DCS Panels folder in the Domain Explorer.
-
Right-click the selected panel, then on the shortcut menu, click Actions > I/O Assignment.
-
On the module toolbar, click to open the I/O Assignment Filter dialog box.
-
Select the first three filtering criteria and click OK.
-
In the I/O Assignment window, select tag 101-LT -201 and drag it to channel 3 in the right side pane.
-
On the Control System Tag Properties dialog box, type BLI 201 and click OK.
-
Now close the I/O Assignment window and select marshaling rack 101-MR-DCS-001.
-
Right-click the selected panel, then on the shortcut menu, click Actions > Connection.
-
In the Terminal strip list, select 101-MR-DCS-001, TP-1.
Note that your tag wiring has been propagated from the DCS to the marshaling rack terminals.
-
Close the Connection window.
-
Right-click the same marshaling rack again, then on the shortcut menu, click Actions > Cross Wiring.
-
Click to find matching terminals for automatic cross wiring.
The software finds matching terminals for automatic cross-wiring. You can view them by scrolling down in the Primary Terminal Strip pane:
-
Click to perform the automatic cross wiring.
-
Close the Cross Wiring window.
You have successfully added a new tag to your wiring.