Loading <xxx> ... Using input file attributes only.
Meaning: Attribute creation mode not supported when loading PODs.
Recovery: Change creation setting to attributes in input file only, or use a PCF or IDF instead of a POD as input.
Symbol file <xxx> not found.
Meaning: The symbol file path name in the symbols section of the configuration file does not exist.
Recovery: Correct the path name specified in the Symbols section of the XML configuration file
Unable to load master symbol definitions.
Meaning: The symbol definitions file could not be found.
Recovery: Check the MasterSymbolsFile setting in I-VIEW CAD.exe.config. Ensure that the file exists. Usually, this message is caused by one of the following:
-
there is a problem with the install kit
-
the configuration file has been modified
-
the symbols.asc file has been deleted