Option Switch 116 also enables the prevention of unwanted skews, but uses a dimension tolerance rather than an angle tolerance.
Example 1: OS 116 = 0
In the following illustration, a 1mm movement in the N/S plane causes a skew to be generated (A).
Example 2: OS 116 = 250
In the following illustration, setting a 2mm cut-off value suppresses the generation of the unwanted skew.
Option Switch 115 uses an angular tolerance to control skew generation. Of the two
option switches, using Option Switch 116 is the preferred method; however, if both
are set, Option Switch 115 takes precedence.