Controls the format of imperial measurements on the isometric drawing.
-
Standard outputs measurements using the standard ft/in format: 6' 10.3/4".
-
Dash inserts a dash between the feet and inches: 6'-10.3/4".
-
Space Dash inserts a blank space instead of a period ( . ) between inches and fractions of an inch: 6'-10 3/4".
-
Stacked Dash outputs stacked fractions with a dash: 6'-10¾". This setting applies only to MicroStation .dgn output.
-
Stacked outputs stacked fractions without a dash: 6' 10¾". This setting applies only to MicroStation .dgn output.
-
1DecimalPlace outputs decimal inches to one decimal place.
-
2DecimalPlace outputs decimal inches to two decimal places.
-
3DecimalPlace outputs decimal inches to three decimal places.
-
4DecimalPlace outputs decimal inches to four decimal places.
Two additional setting are available for controlling the format of pipe dimensions:
-
Use inches only plots dimensions in inches only
-
Use feet and inches if above nn inches plots dimensions greater than the user-specified value (nn) in feet and inches.
Defines:
Option Switch - 41, Pos 3
I-Configure - Drawing.Dimensions.ImperialFormat