-
Click Start > All Programs > Intergraph Spoolgen > Tools > I-Configure to open the I-Configure application.
-
Select the current Spoolgen project in the Project View panel.
-
Click Project Defaults on the horizontal toolbar to open the Project Defaults dialog box.
-
Set Interactive Spooling to On.
-
Click OK to save the changes, and close the dialog box.
-
When Interactive Spooling is set to On, the software observes the standards listed below.
-
SGImport settings of the properties listed below are used to control interactive spooling behavior:
-
Spools > Settings > Allocation
-
Spools > Settings > Break at Unions
-
Spools > Settings > Site Welds are not assigned to Spools
-
-
For any isometric drawing style selected for drawing generation, the following standards apply:
-
Spools > Settings > Type is set to None
-
Spools > Settings > Allocation is set to User
-
-
-
When Interactive Spooling is set to Off, Spools > Settings > Type and Spools > Settings > Allocation use the values currently defined for the selected isometric drawing style.