Smart Weld Quality Management System Application Server Hardware recommendation - Intergraph Smart WQMS - 2019 R1 (5.0) - Installation - Hexagon PPM

Intergraph Smart Weld Quality Management System Installation (2019 R1)

Intergraph Smart WQMS
Installation & Upgrade
2019 R1 (5.0)

The below hardware is recommended for Weld Quality Management System 2019 R1:

  • 16 core high-end server processor - To host the data for one Weld Quality Management System site. For each additional site, add 8 cores.

  • 64 GB RAM - To host the data for one Weld Quality Management System site. For each additional site, add 32 GB.

  • 5 GB free disk space for software installation - 5 GB and an additional 3 GB free disk space on the drive where the TEMP folder is located.

  • 1000 BaseT or higher network interface.

  • DVD drive access, either local or through a network connection - For installation media.

  • These application server hardware recommendations are based on the assumption that this server hosts one typical Weld Quality Management System site and does not host other major Intergraph or third-party applications. Hardware size for servers depends on many factors, such as the number of concurrent users per site, the size of the project (which translates into the size of the database), and other softwares that are running on the machine.

  • For each additional site in this server’s configuration, at least additional 8 cores and 32 GB of memory should be added to the configuration.

  • The memory required for each site depends on concurrency and system usage.

  • Performance capacity planning should be done to obtain the accurate measurement.

  • These Weld Quality Management System application server hardware recommendations also apply to the virtual servers. For virtual deployments, the same amount of RAM, disk space, and CPU capacity required for a similar physical deployment should be available to the virtual machine.