Fabrication Structural - Intergraph Smart WQMS - 5.0 - Help - Hexagon PPM

Intergraph Smart Weld Quality Management System Help

Language
English
Product
Intergraph Smart WQMS
Search by Category
Help
Smart WQMS Version
5.0

In Structural module, you must first load the weld components in Administration > Weld Components module and then load the structural welds in the Structural > Welds module. After the welds are loaded, they undergo the following stages of inspection to check the quality of a weld.

  • Material Verification

  • Fit-Up Verification

  • Material Verification + Fit-Up Verification

  • Pre weld Heat Treatment

  • Visual Inspection

  • Non-Descrutive Testing BSR

    • Ultrasonic Testing (UTE)

    • Hardness Testing (HDT)

    • Radiography Testing (RTE)

    • Positive Material Identification Testing (PMI)

    • Magnetic Particle Inspection Testing (MPI)

    • Ferrite Count Testing (FCO)

    • Dye Penetrant Inspection Testing (DPI)

    • Phase Array Ultrasonic Testing (PAU)

    • Post Weld Heat Treatment (PWHT)

    • Time of Flight Diffration (TOFD)

  • Post Weld Heat Treatment Inspection

  • Non-Descrutive Testing (ASR)

    • Ultrasonic Testing (UTE)

    • Hardness Testing (HDT)

    • Radiography Testing (RTE)

    • Positive Material Identification Testing (PMI)

    • Magnetic Particle Inspection Testing (MPI)

    • Ferrite Count Testing (FCO)

    • Dye Penetrant Inspection Testing (DPI)

    • Phase Array Ultrasonic Testing (PAU)

    • Post Weld Heat Treatment (PWHT)

    • Time of Flight Diffration (TOFD)