Option codes for bolts, gaskets, nuts, washers, and clamps can be selected from the BoltOption, GasketOption, NutOption, WashOption, or ClampOption codelists, respectively.
An example for bolts is described below.
We get the available option codes for the bolt short code from the BoltOption codelist:
-
Assign the template that has the BoltOption sheet and corresponding option codes defined to the ZI_SP3D_TP project default.
-
Define this template on the Templates screen as displayed below.
-
Assign the option codes 1, 5, 10, and 15 to the BoltOption sheet.
-
Assign the general config where the short code list for bolts is defined to the ZI_SP3D_GC project default.
-
Define this general configuration on the General Configuration screen as displayed below.
The SI_BOLT_SHORT_CODE_LST config item specifies the short code for bolts.
-
Set the ZS_LOV_OC project default to SP3D to restrict the available option codes to the option codes assigned to the template sheets.
-
Open the Short Codes screen, select BLTG, click Go to next block to open Window 2, and select the Allowed Option Codes tab.
-
Open the LOV
in the Option Code field.
The options assigned to the BoltOption sheet are available for selection.
-
In the same way, define the sheets for clamps, gaskets, nuts, and washers (ClampOption, GasketOption, NutOption, and WashOption) with the appropriate option codes on Data Table Configuration screen.
On General Configuration screen, assign the appropriate short codes to the following config items:
-
Clamp: SI_CLAMP_SHORT_CODE_LST
-
Gasket: SI_GASKET_SHORT_CODE_LST
-
Nut: SI_NUT_SHORT_CODE_LST
-
Washer: SI_WASHER_SHORT_CODE_LST
-