Line Routing Ribbon - Intergraph Smart P&ID - Help - Intergraph

Intergraph Smart P&ID Help

Language
English
Product
Intergraph Smart P&ID
Search by Category
Help
Smart P&ID Version
9 (2019)
Smart Engineering Manager Version
10 (2019)
SmartSketch Version
10.0(2018)

Appears when you select a line element from the Catalog Explorer list view or the Engineering Data Editor or when you select an existing line in a drawing. You can dock the Line Routing ribbon in the main toolbar; it remains there for the current design session unless you move it again.

PPM All Outputs Graphic Diagonal Mode

Select the Diagonal Mode button or press the ALT key to route lines in any direction, instead of the usual constraint of horizontal or vertical line routing. This procedure is usually popular with signal and utility lines, but you can use it for any line routing.

PPM All Outputs Graphic Insert Segment Mode

Select the Insert Segment Mode button or press the SHIFT key to insert line segments instead of routing new lines or instead of moving existing lines.

PPM All Outputs Graphic Break Run

Allows you to break a pipe run. After you break the run, select the pipe run and select Edit > Properties to enter or change any property values. See Break a Pipe Run.

PPM All Outputs Graphic Join Runs

Allows you to join two pipe runs. When joining pipe runs with different property values, the properties of the resultant pipe run after using Join Runs depend on several factors. See Join Pipe Runs.