Updating Options Manager Settings - Intergraph Smart P&ID - 11 - Help - Intergraph

Intergraph Smart P&ID Help

Language
English
Product
Intergraph Smart P&ID
Search by Category
Help
Smart P&ID Version
11
Smart Engineering Manager Version
12
SmartSketch Version
11

You can force the software to regenerate the drawing by using the Update Symbology command. This command refreshes the graphic symbology of symbols in your drawing based on the current settings in Options Manager. The ApplySettingsCmd macro also updates the line settings, Minimum Connector Segment and Routing Self-Avoidance, so that the current values in Options Manager are reflected in the drawing.

The symbology and other settings defined in Options Manager usually take effect only in those drawings created after those values are defined. You can force changes in Options Manager to appear in the current drawing by updating Options Manager settings, regardless of when the drawing was created.

  • Any user can update drawings using these commands. However, check your permissions, which are assigned in Smart Engineering Manager, to find out if you can make changes to the plant-wide symbology in Options Manager.

  • After you load the current plant-wide definitions into your drawing, you cannot revert to previous definitions. However, you can always override plant-wide symbology choices in your drawing by using drawing filters and choosing alternate symbology for items.