On the Administration>Global Setup> Project Defaults page, you can define the project defaults (parameter defaults for the projects).
Most modules require that you define a specific setting here only, for example, the default list status that is assigned to BOM positions in the Bill of Materials> Maintain BOM - Edit BOM module.
To know more about the tabs, refer tab details in Project Group Defaults.
Each tab consists of following columns:
|
Columns Name |
Description |
|---|---|
|
Parameter |
Name of the setting |
|
Description |
Description of the setting |
|
Value |
Value of the setting defined by the user |
|
Value Description |
Description of the associated value |
|
Defined On |
Describes the level at which the setting is defined. For example, at product group or project or discipline level.
|
|
Mandatory |
Can have two values (Y and N) |
|
Default Vale |
Default value of the setting |
If it is at discipline level,then it indicates that the project default is set at
least for one of the corresponding disciplines. To know more, click the respective
project default.
-
To edit any setting, click Edit in the interactive grid.
-
To view the history of any project default, click the Parameter name.
-
You can copy the values of a project, by following these steps;
-
To copy values of any project, click Copy Value.
-
In the pop-up, from the LOV, select the required Project.
-
If you want to copy all the values, select Copy all values. Else, to copy only new values, select Copy only new PDs.
-
To continue, click Start, or click Cancel to close the pop-up..
-
-
You can check whether the values assigned to the project defaults are correct or not.To do so, follow these steps:
-
Click Check Value.
-
If there are incorrect values, a pop-up displays showing the affected project defaults.
-
Click OK to close it.
-
Open the respective project default, and make the changes.
-
To check it again click, Check Value.
-