Use this procedure to modify base condition values when entering data for Control Valve, Relief Valve, or Flowmeter calculations, from the Process Data or Calculation modules.
-
Open the process data sheet for an instrument tag from the Process Data module or the Calculation module.
-
Scroll to the BASE CONDITIONS section.
-
Select a base pressure unit of measure, and beside Pressure type the base pressure.
-
Select a temperature scale, and beside Temperature, type the base temperature.
-
According to the state that you selected under Fluid, select the basic property as follows:
-
If the state is solid/powder, do one of the following:
-
Select Density @base, select a unit of measure, and type the density value.
-
Select Specific Gravity @base, and type the specific gravity value.
-
-
If the state is liquid, do one of the following:
-
Select Density @base, select a unit of measure, and type the density value.
-
Select Specific Gravity @base, and type the specific gravity value.
-
-
If the state is water, do one of the following:
-
Select Density @base, select a unit of measure, and type the density value.
-
Select Specific Gravity @base, and type the specific gravity value.
-
-
If the state is gas/vapor, do one of the following:
-
Select Density @base, select a unit of measure, and type the density value.
-
Select Compressibility @base, and type the compressibility value.
-
-
If the state is steam, beside Compressibility @base, type the value.
-
-
To save your changes, on the module toolbar, click .