The options on this tab allow you to determine the margins of the working area in enhanced reports that are associated with the layout.
Working area margins
Displays the margins of the initial working area on the drawing page. Drag the edges of the working area to set the margins to the required position. Note that when you set the working area margins, the defined area includes the title block. The software generates the drawing starting from the top left corner at the position relative to the title block that you specified on the Title Block tab. If any drawing elements extend beyond the right and bottom limits of the working area, the software displays those elements on a new sheet.
Units
Select the units to specify for the working area margins: inches, millimeters, or twips.
Left
Specifies the width of the left margin of the working area in the selected units.
Right
Specifies the width of the right margin of the working area in the selected units.
Top
Specifies the width of the top margin of the working area in the selected units.
Bottom
Specifies the width of the bottom margin of the working area in the selected units.
Reset
Resets the working area margins with a default value of 20 twips for all margins.