Meaning: The software could not get or update the hole trace symbol, possibly because the
symbol was not created correctly.
Recovery:
For a sketched hole:
1. Set the Locate Filter to Holes. 2. Select the hole in error. 3. Click Sketch on the ribbon. 4. Click Sketch 2D on the ribbon. 5. Re-sketch the hole in the 2D environment. 6. Click Finish in the 2D environment. 7. Click Finish on the ribbon.
|
For a non-sketched hole:
1. Set the Locate Filter to Holes. 2. Select the hole in error. 3. From the Hole Clearance Rule list, select a different option. 4. Click Finish.
|