-
Click Place Edge Features by Offset .
-
Click Select Edge .
-
Select the edge of the plate or profile part to which to add the edge features.
-
Click Select Reference .
-
Click Accept .
-
Click By Table .
-
Specify the number of features to place and the distance between each edge feature.
The offset distance (positive or negative) is applied relative to the direction of the selected edge as indicated by the directional arrow.
-
Specify whether to place feature at the reference point. The software does not support this option if the reference does not naturally intersect the selected edge.
-
Select the Definition to specify how the software measures the offset distance from the reference. Options available are Along Girth, Vertical, Transverse, and Longitudinal. The software does not support Along Girth if the reference does not naturally intersect the selected edge.
-
Click OK.
You must clear Rule Based to select the edge feature shape.
-
Select the edge feature from the Shape list.
-
Click Finish.