Place Member Generic Assembly Connection Command - Intergraph Smart 3D - Help - Hexagon

Intergraph Smart 3D Structural Detailing

Language
English
Product
Intergraph Smart 3D
Subproduct
Structural Detailing
Search by Category
Help
Smart 3D Version
13.1

PlaceMemberGenericAssemblyConnectioni Places an assembly connection between a member part and a bounding part. This command creates the assembly connection, applies the appropriate flange and web cuts, and creates the appropriate physical connections. A typical example is the bounding of a member to the flange and web faces of another member.

StrDtl_Concept_GenericAssemblyConnection

Member generic assembly connections are typically created automatically with Place Linear Member System Command and connected to a detailed plate system or edge reinforcement. You can use Place Member Generic Assembly Connection PlaceMemberGenericAssemblyConnectioni in situations where the connection is not created automatically.

The member is bounded to ports at the faces or edges of the bounding part. The ports used can be edited after creating the assembly connection. This command supports the following situations:

  • A member bounded by a plate edge port.

  • A member bounded by a plate face port.

  • A member bounded by a flange edge port.

  • A member bounded by a web or flange face port.

  • The selected bounding geometry must be on detailed parts.

  • This command can generate physical connections to a single plate part.

Place Member Generic Assembly Connection Ribbon

Modify Member Generic Assembly Connection Ribbon

What do you want to do?