The bevel value calculation is based on the MaxShapePosition value of the part shape. The default value is 0.
-
If the value is set to 0, the software uses the physical connection bevel properties to make the correction.
-
If the value is set to 1, the part shape is computed to the long point.
-
If the value is set to 2, the part shape is computed to the short point.
The following example shows the effect of MaxShapePosition on part shape manufacturing dimensions.
MaxShapePosition |
2 |
0 |
1 |
Part Thickness |
10 mm |
10 mm |
10 mm |
Angle N |
60° |
60° |
60° |
Angle D |
15° |
15° |
15° |
Depth D |
7 mm |
7 mm |
7 mm |
Shift |
10.25 mm |
10.25 mm |
10.25 mm |
Length |
4000 mm |
4000 mm |
4000 mm |
Final Part Length |
4330.229 mm |
4337.301 mm |
4347.550 mm |
Bevel Correction Calculations