-
Click Route Pipe Command on the vertical toolbar.
-
Click Arc Routing on the horizontal ribbon.
-
Click Start Point and click to set the run starting point.
-
On the New Pipe Run Dialog, type a name for the Pipe Run. If you do not type a name, the software automatically generates a name. See Select pipe run settings
-
Click OK to close the dialog.
If you are connecting the arc pipe to an existing run, select its name from the Run box.
-
Type the Arc radius in the corresponding box.
-
Click Center Point , and click to set the run center point.
-
Click End Point , and click to set the run end point.
-
Type the Arc angle in the corresponding box.
-
Click Finish to place the arc pipe.