Adjust the slope to keep the pipe run within the slope tolerances - Intergraph Smart 3D - Help - Hexagon

Intergraph Smart 3D Piping

Language
English
Product
Intergraph Smart 3D
Subproduct
Piping
Search by Category
Help
Smart 3D Version
13
SmartPlant Foundation / SDx Version
10

When you move sloped pipe run components, connected components can move out of the minimum slope tolerance. This often happens when you move a loop or change the slope tolerance on an existing pipe run. To adjust the components so that they are within the minimum slope tolerance, use the following procedure:

  1. Select the turn feature (typically an elbow) to move. For example, you might need to move an elbow so that the attached pipe slope is within the slope tolerance.

  2. Click Modify Slope Modify Slope to display the Modify Slope Dialog.

  3. Select the pipe leg to change.

  4. Select a slope from the list that puts the component within the minimum slope tolerances.

  5. Click OK to change the slope of the component.

  6. Repeat steps 1 through 5 for each component that needs to change.