IntergraphAlternativeTexts - Intergraph Smart 3D - Help - Hexagon

Intergraph Smart 3D Isogen Isometric Drawings

Language
English
Product
Intergraph Smart 3D
Subproduct
Drawings and Reports
Search by Category
Help
Smart 3D Version
13
Isogen Version
13.0(2016)

Provides options for defining user-specified text strings that are output on the isometric drawing.

Open the grid, and then define the attributes listed below as needed.

  • TextPurpose provides a value corresponding to the text to replace. The values provided are Smart 3D-specific. The table below lists the Intergraph Alternative Text options that are currently supported by the software.

DEG_DEFAULT defines the text output on the drawing to denote degrees.

HOR_DEFAULT denotes the horizontal orientation angle.

IN_LENGTH_DEFAULT defines the text output on the drawing to denote length in inches.

MM_DEFAULT defines the text output on the drawing to denote unit measurement in millimeters.

NO_SPOOL_DEFAULT defines the text output on the drawing if there are no spools in the drawing.

ORIENT_HANDLE_DEFAULT defines the text output on the drawing

UNDEFINED_INSULATION_SPEC_DEFAULT defines the text output on the drawing to denote the insulation specification is undefined for a feature or a run.

UNDEFINED_PAINT_SPEC_DEFAULT defines the text output on the drawing to denote the painting specification is undefined for a feature or a run.

UNDEFINED_TRACING_SPEC_DEFAULT defines the text output on the drawing to denote the tracing specification is undefined for a feature or a run.

VOR_DEFAULT denotes the vertical orientation angle.

The following AText options generate abbreviate direction strings, such as 35 N 45 E. Used when the orientation is non-orthogonal.

  • D_DEFAULT

  • E_DEFAULT

  • N_DEFAULT

  • S_DEFAULT

  • U_DEFAULT

  • W_DEFAULT

These AText options generate full text direction strings (such as EAST or SOUTH). Used when the orientation is orthogonal.

  • DOWN_DEFAULT

  • EAST_DEFAULT

  • NORTH_DEFAULT

  • SOUTH_DEFAULT

  • UP_DEFAULT

  • WEST_DEFAULT

To override all direction settings, you must define the Smart 3D AText option and the Isogen AText option

Defines:

Option Switch - N/A
I-Configure - S3D.IntergraphAlternativeTexts