Defines the minimum slope treated as a fall. The default value is 5°. The minimum value is 1°.
Type 0 to use a 5° angle cut-off or its equivalent depending upon the type of indication selected by Fall Representation. Alternatively, type a value that defines a cut-off number to suit the type of indication selected by Fall Representation.
-
For fall cut off of 5 Degrees, type 5 or 0.
-
For fall cut off of 1:11 Ratio, type 11.
-
For fall cut off of 9 Percent, type 9.
-
For fall cut off of 5 Grads, type 5.
-
For fall cut off of 1" Per foot, type 1.
-
For fall cut off of 88 mm per meter, type 88.
Defines:
Option Switch - 20
I-Configure - Drawing.Format.FallCutOff
-
Always set Cut Off to 0 when sloping pipeline indication has been suppressed by Fall Representation.
-
Slopes steeper than the cut-off value are shown with a 2D or 3D box or triangle skew indication as appropriate.