Before you complete the steps in this procedure, you must install the Piping Specification Remote Access Server service and configure the COM+ application. For more information, see Install Smart 3D Client Software.
You must have administrator privileges on the computer in order to perform this installation procedure.
-
Click Start > Run, and then click Browse in the Run dialog box.
-
Navigate to [Product Folder]\RefData\Tools\Bin\SetSiteForPipingSpecRemoteAccess.exe, and click OK.
-
Click OK in the Run dialog box.
-
In the Set Site Database for Piping Spec Remote Access dialog box, enter the Site and Site schema database names and servers in the appropriate fields.
-
Click OK.
-
In order to use Piping Specification Remote Access you must perform additional installation and configuration on the computers running SmartPlant P&ID. See the Installing SmartPlant 3D Piping Specification Remote Access Client section in the SmartPlant P&ID Installation and Upgrade Guide for more information about installing the SmartPlant 3D Piping Specification Remote Access Client. Also, see the Piping Specification Utility section in the SmartPlant P&ID Utilities Guide for additional configuration information.
-
The "server" used by the SmartPlant 3D Piping Specification Remote Access Client and the SP3D P&ID Client Tester application is the computer on which the SmartPlant 3D Piping Specification Remote Access Server COM+ application has been installed and configured. This server can be different from the database server on which the Site database server and Site schema server reside.