Reference Data Setup - Intergraph Smart 3D - Installation & Upgrade - Hexagon

Intergraph Smart 3D Installation

Language
English
Product
Intergraph Smart 3D
Search by Category
Installation & Upgrade
Smart 3D Version
13.1

Prior to installing Smart 3D Reference Data on the database server, verify that the server computer meets the required hardware and software requirements and that all prerequisite software has been installed. For more information about hardware and software requirements, see Smart 3D Database Server Recommendations. For more information about the prerequisite software, see Loading Prerequisite Software on the Database Server.

Refer to Install Smart 3D Client Software for setup instructions.

If you have an older version of Smart 3D software installed on your computer, uninstall it before loading the new software. Refer to the section entitled Remove Smart 3D Software.

Approximately 4.25 GB of hard disk space is required to load the Smart 3D Reference Data software. Prior to installing Smart 3D Reference Data, select and size the hard disk partitions accordingly. For additional information, see Disk Partitioning Guidelines.

You must share the SharedContent folder after installation is complete. For more information, see Configure Network Shares.