Show support dimensions on fabrication drawings - Intergraph Smart 3D - Help

Intergraph Smart 3D Hangers and Supports

Language
English
Product
Intergraph Smart 3D
Subproduct
Hangers and Supports
Search by Category
Help
Smart 3D Version
12 (2018)

To show the dimensions on fabrication drawings of a support, annotate the support in following ways:

  • Add a note to the key points, and activate Show dimensions on the support properties page.

  • Add a control point, and activate Show dimensions on the support properties page if key points are not available at the required location.

You can also add dimensions in additional ways if reference data customization is performed by an administrator.

  • Add a note to the key points available in the support, using Custom Support Definition (CSD).

  • Add a dimension port to the support using the CreateNote function and then set the Dimensioned property to True in Note of CSD if key points are not available or are not at the required location.

  • Add a control point to the support using the CreateNote function in CSD if the key points are not available or are not at the required location.

See Custom Support Definition (CSD) Examples in Hangers and Supports Reference Data Help.

To automatically show a dimension on the fabrication drawing, you need a key point or a control point for the dimension start and dimension end.

What do you want to do?