Shoe Shape - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
11 (2016)

IJUAhsSmartShapeType::SmartShapeType - Specifies the classification of the shape. Enter a codelist number from the hsSmartShapeType sheet in the HS_S3DParts_Codelist.xls workbook.

IJUAhsShoeType::ShoeType - Specifies the type of shoe. Enter a codelist number from the hsShoeType sheet in the HS_S3DParts_Codelist.xls workbook.

IJUAhsShoeHeight::ShoeHeight - Specifies the total height of the shoe including the base.

IJUAhsShoeWidth::ShoeWidth - Specifies the width of the shoe. You must enter a positive value.

IJUAhsShoeLength::ShoeLength - Specifies the length of the shoe. You must enter a positive value.

IJUAhsShoeShape::ShoeAngle - Specifies the slope angle of the pipe. Extension plates are sloped using this angle.

IJUAhsShoeSpaceFrm::ShoeSpaceFrm - Specifies the codelist value for the leg spacing. The following codelist values are supported:

  • 1 - Leg space is measured from the edge

  • 2 - Leg space is measured from the center

IJUAhsVerticalLeg::LegLowerSpacing - Specifies the spacing of the legs at the bottom. This property is used with ShoeType 7. This value must be less than the ShoeSpacing value. For type 7, ShoeSpacing is the space of the legs at the top.

IJUAhsShoeTapLength::TaperedLength - Specifies the spacing upper side length of the leg.

IJUAhsShoeTapAng::TaperedAngle - Specifies the angle of taper of the vertical leg.

Use TaperedLength or TaperedAngle to get tapered vertical members.

IJUAhsTaperStartFrom::TaperStartFrom – Specifies the length from the point at which the leg member starts.

IJUAhsTaper:Ends:TaperEnds - Defines the length from the point at which the tapering of the leg member ends from the top of the leg.

IJUAhsContinous::Continous - Specifies whether the shoe shape is continuous. Enter a codelist number from the hsYesNo sheet in the HS_S3DParts_Codelist.xls workbook.

The Continuous option is not available for tapered shoe.