Gusset Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
11 (2016)

The following properties define the basic geometry of the optional gusset.

IJUAhsWidth5::Width5

Specifies the primary width of the gusset. This value must be greater than zero, or no gussets are modeled.

IJUAhsLength5::Length5

Specifies the primary length of the gusset. This value must be greater than zero, or no gussets are modeled.

IJUAhsThickness5::Thickness5

Specifies the primary thickness of the gusset. This value must be greater than zero, or no gussets are modeled.

IJUAhsWidth6::Width6

Specifies the secondary width of the gusset. This value must be greater than or equal to zero.

IJUAhsLength6::Length6

Specifies the secondary width of the gusset. This value must be greater than or equal to zero.

IJUAhsOffset3::Offset3

Specifies the horizontal position of the gusset's corner.

IJUAhsOffset4::Offset4

Specifies the vertical position of the gusset's corner.

IJUAhsMulti1::Multi1Qty

Specifies the quantity of gussets on each side. Gussets are not shown when Multi1Qty is set to zero.

IJUAhsMulti1::Multi1LocateBy

Specifies the location of the bolts. Each bolt can be located in two ways.

1 - Relative to center of the group
2 - Relative to edge.

The exact meaning depends on the quantity of bolts. This value can be 0 (nothing), 1 (center), or 2 (Edge).

IJUAhsMulti1::Multi1Location

Specifies the distance for the exact location of the gussets depending on Multi1LocateBy and Multi1Qty. This value can be either a distance to the end or a center-to-center spacing between the gussets.