Weld Plate/Bolt Blocks Shield Properties - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
11 (2016)

IJUAhsThickness3::Thickness3 (optional)

Specifies the thickness of the weld plate\bolting block. All plates\blocks have the same thickness. If Thickness3 is less than or equal to zero, then the weld plates are not drawn.

IJUAhsAngle5::Angle5

Specifies the total angle of the plate. The plate is always centered on the pipe centerline. The weld plates on both sides of the pipe will have the same dimensions. Angle5 takes precedence over Height1.

  • If Thickness3 is greater than zero, then either Angle5 or Height1 is required.

  • Angle5 must be greater than 180 – (Angle1 + Angle3)

  • Use Height1 instead of Angle5 for a SQUARE or RECTANGLE plate.

  • If Angle5 is used, the plate is drawn as a CURVED PLATE.

IJUAhsHeight1::Height1

Specifies the height of the left plate. This value is measured from the inside bottom corner to the inside top corner. The plate is always centered on the pipe centerline. The plates on both sides of the pipe have the same dimensions. Angle5 takes precedence over Height1.

  • If Thickness3 is greater than zero, then either Angle5 or Height1 is required.

  • Height1 must be greater than 180 – (Angle1 + Angle3)

  • Use Height1 instead of Angle5 for SQUARE or RECTANGLE plates.

  • If Angle5 is used, the plate is drawn as a CURVED PLATE.

IJUAhsLength3::Length3

Specifies the length of the plate\block. If Length3 equals zero and Thickness3 is greater than zero, use the smaller of Length1 and Length2. If there is more than one plate or block on each side, they have the same length.

IJUAhsMulti1::Multi1Qty

Specifies the number of plates. This is same on both sides.

IJUAhsMulti1::Multi1LocateBy

Specifies how to locate the plates. This is the same on both sides. The plates are located in two ways.

1 - Relative to center of the group
2 - Relative to edge.

The exact meaning depends on the quantity of plates. This value can be 0 (nothing), 1 (center), or 2 (Edge).

IJUAhsMulti1::Multi1Location

Specifies the location of plates. This is the same on both sides.