Swivel Ring - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
11 (2016)

Library Name: SmartParts
Workbook: HS_S3DParts.xls
Codelist: HS_S3DParts_Codelist.xls
ProgID: HSSmartPart,Ingr.SP3D.Content.Support.Symbols.SwivelRing
Part Name: Swivel Ring
Part Description: Swivel Ring SmartPart

Prerequisites

Make sure that the following BulkLoad.xls workbooks in

[Product Folder]\CatalogData\BulkLoad\DataFiles\ is already bulkloaded.

  • AllCodeLists.xls

  • AllCommon.xls

  • GenericNamingRules.xls

  • HS_System.xls

  • HS_System_Codelist.xls

  • HS_S3DParts_Codelists.xls

Sample SmartPart data is provided in HS_S3DParts.xls which is delivered in

[Product Folder]\CatalogData\BulkLoad\DataFiles.

Part Placement

To place a sample swivel ring SmartPart delivered with the catalog:

  1. Click Tasks > Hanger and Supports.

  2. Place a design support on a pipe.

  3. Click Place Part , and then select the design support.

  4. In the Select Part dialog box, select a part from Parts > SmartParts > S3D Standard > Pipe Clamps>Adjustable Swivel Ring as shown below.

Part Properties

Millimeters (mm) is the default unit. Use in at the end of dimensional values to specify inches. Ports are shown as points highlighted in red.

Local Coordinate System

The part origin is at the pipe centerline where the Route port is located.

With this coordinate system, the swivel ring shows up in the most-frequently-used orientation when using the AddPart command.