These properties define the round block properties at the ends of the two sides used for holding the pin/bolt. If no values are provided, then the side blocks are extended to hold the pin/bolt.
IJUAhsDiameter2::Diameter2
Specifies the outside diameter of the round ends of the clevis. If this value is set to zero or to a negative, then the round ends are not drawn.
IJUAhsThickness2::Thickness2
Specifies the thickness of the round ends of the clevis. If this value is set to a negative, then zero is used.
IJUAhsGap2::Gap2
Specifies the gap between the round ends of the clevis. This value can be set to zero; negative values, however, are not acceptable. If this value is set to a negative, then zero is used.
