These properties specify the end nut shape properties for the clevis.
IJUAhsShape1::Shape1Type
Specifies the codelist number of the type of shape as defined in the hsShapeType sheet in the HS_S3DParts_Codelist.xls workbook.
-
1 - Round
-
2 - Square
-
3 - Hex
IJUAhsShape1::Shape1Width1
Specifies the outside dimension of the end nuts. If this value is set to zero, then the end nut shape is not displayed.
-
1 - Round
-
2 - Square
-
3 - Hex
IJUAhsShape1::Shape1Width2
Specifies the value only for NutShape2 (square). This value is used to create a rectangular nut instead of a square nut. If this value is set to zero or is not specified, then NutShape2 is drawn as a square.
IJUAhsShape1::Shape1Length
Specifies the thickness of the end nut shape. Only positive values are acceptable. If this value is set to zero or to a negative, then the end nut shape is displayed.