Basic Strap Attributes - Intergraph Smart 3D - Reference Data - Hexagon PPM

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
Hangers and Supports
Search by Category
Reference Data
Smart 3D Version
13

The basic strap attributes specify the shape and size of the strap.

IJUAhsStrap::StrapWidthInside

Specifies the distance between the legs of the strap. The thickness of both the sides of a horizontal traveler must be a positive number. If the thickness is zero, the software does not show the sides.

Pipe Saddle - Strap Att - Strap Inside Width

IJUAhsStrap::StrapHeightInside

Specifies the height from the base of the strap to the top of the strap.

Pipe Saddle - Strap Att - Strap Height Width

IJUAhsStrap::StrapThickness

Specifies the thickness of the rectangular stock that is used to make the strap. If the value is zero, the software does not draw a strap shape.

Pipe Saddle - Strap Att - Strap Thickness

IJUAhsStrap::StrapStockWidth

Specifies the width of the rectangular stock that is used to make the strap. If the value is zero, the software does not draw a strap shape.

Pipe Saddle - Strap Att - Strap Stock Width

IJUAhsStrap::StrapWidthWings

Specifies the width of the strap including the wings, if the wings are available. If the value is either zero or less than StrapWidthInside plus 2 times StrapThickness, (StrapWidthInside + 2 * StrapThickness), then the software does not draw the wings. This attribute value affects the position of the gussets.

Pipe Saddle - Strap Att - Strap Width Wings