Stanchion Shape Properties - Intergraph Smart 3D - Reference Data - Hexagon PPM

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
Hangers and Supports
Search by Category
Reference Data
Smart 3D Version
13

IJUAhsStanShape::StanShape

Specifies the stanchion shape. Stanchion shape can be used as either top shape or bottom shape of the part. Stanchion shape can be used in IJUAhsBotShape::BotShape or IJUAhsTopShape::TopShape (at part class level). Allowed values are

1 - Cylinder
2 - Square/Rectangle
3 - Standard Steel

The above values are codelisted values from the hsDummyStanc sheet of the HS_S3Dcodelist.xls workbook.

Bottom Shape

Top Shape

IJUAhsStanHeight::StanHeight

Specifies the total height of the stanchion shape excluding the plate height. If StanHeight is not specified, then the shape is of variable length.

IJUAhsStanWidth::StanWidth

Specifies the width of the stanchion. StanWidth must be a positive value. If the stanchion shape is round, then StanWidth is used as the diameter. If the stanchion shape is set to standard steel, then StanWidth is not used.

IJUAhsStanDepth::StanDepth

Specifies the depth of the stanchion shape. If the stanchion shape is either round or standard steel, then StanDepth is not used.