These properties define the geometry of the beam clip body.
For these properties, millimeters (mm) is the default unit of distance. Use "in" at the end of the dimensional value to specify inches.
IJUAhsClip::ShapeType
Specifies the codelist number of the clip shape type as defined in the hsShapeType sheet in the HS_S3DParts_Codelist.xls workbook. The shape origin is shown by
The valid values include:
IJUAhsClip::ClipWidth1
Specifies the first width of the beam clip. This value must be greater than or equal to zero.
For Shape P and Q, if ClipWidth1 is not given or Zero, then ClipWidth1 is calculated in the code as shown below.
ClipWidth1 = FlangeWidth/2+ClipGap-Gap/2
IJUAhsClip::ClipWidth2
Specifies the second width of the beam clip. This value must be greater than or equal to zero.
For Shape P and Q, if ClipWidth2 is not given, then it is calculated in the code as shown below.
For P,
ClipWidth2 = FlangeWidth/2+ClipGap - Gap/2 + ClipThickness
For Q,
ClipWidth2 = FlangeWidth/2 + ClipGap - Gap/2
IJUAhsClip::ClipWidth3
Specifies the third width of the beam clip depending on the shape of the clip. This value must be greater than or equal to zero.
For Shape Q, if ClipWidth3 is not given, then it is calculated in the code as shown below.
ClipWidth3 = Gap + ClipThickness
IJUAhsClip::ClipThickness
Specifies the first thickness of the beam clip shape. This value must be greater than zero.
IJUAhsClip::ClipThickness1
Specifies the second thickness of the beam clip shape. This value must be greater than zero.
IJUAhsClip::ClipThickness2
Specifies the third thickness of the beam clip shape. This value must be greater than zero.
IJUAhsClip::ClipHeight1
Specifies the first height of the beam clip shape. This value must be greater than or equal to zero.
For Shape P and Q, if ClipHeight1 is not given, then it is calculated in the code as shown below.
ClipHeight1 = FlangeThickness + 2*ClipThickness
IJUAhsClip::ClipHeight2
Specifies the second height of the beam clip shape. This value must be greater than zero.
For Shape P, if ClipHeight2 is not given, then it is calculated in the code as shown below.
ClipHeight2 = Height3 + 2*ClipThickness