These properties are used to create concrete geometry of the saddle. If these properties are left as blank or zero, then the part creates the dimensions based on the rules provided in the symbol code.
IJUAhsHeight1::Height1
Specifies the height from the base of the concrete saddle to the top of the saddle curved surface. The concrete saddle is drawn only if Height1 is greater than zero.
IJUAhsHeight2::Height2
Specifies the height of the concrete saddle footing. The footing is drawn only if Height1 is greater than zero and Height2 is greater than zero.
IJUAhsLength2::Length2
Specifies the length of the footing. If Length2 is not specified then the software sets Length2 equal to Length1 as the default value for this property.