Specify the attributes of the two vertical side plates of the welded beam attachment. Both side plates must be included.
For these properties, the default unit of distance is mm. Specify in at the end of the dimensional value to use inches (for example 10in).
IJUAhsGap1::Gap1
Specifies the inside gap between the two side plates. The value can be zero but cannot be negative.
IJUAhsThickness1::Thickness1
Specifies the thickness of the two side plates. The value must be positive.
IJUAhsHeight1::Height1
Specifies the total height of the side plates, including the base plate. The value must be positive.
IJUAhsWidth1::Width1
Specifies the width of the side plates. The value must be positive.
IJUAhsOffset1::Offset1
Specifies the left-to-right offset of the side plates from the bolt center. This value is used when the welded beam attachment bolt part is used for non-symmetrical beam attachments. The edge of the side plates will be located at the specified distance from the bolt centerline. The value must be positive. If the value is set to zero, the side plates are centered.