These properties define the geometry of the beam clamp that has a clip with a U-Bolt/J-Bolt.
IJUAhsJUBolt::UBoltWidth
Specifies the center to center distance between the legs of the U-Bolt. This value determines the spacing of the vertical legs of the U-Bolt and the bend radius for the curved part of the U-Bolt. UBoltWidth value must be greater than UBoltRodDia and lesser than the depth of the clip shape.
IJUAhsJUBolt::UBoltLength
Specifies the distance from bottom to top end of the U-Bolt legs.
IJUAhsJUBolt::UBoltRodDia
Specifies the diameter of round stock used to make the U-Bolt. If this value is zero, no U-Bolt shape is drawn.
IJUAhsJUBolt::UBoltFlatSpot
Adds a flat spot to the shape of the rectangular wrap/strap. If UBoltFlatSpot is zero, no flat spot is added to the curved part of the U-Bolt. If UBoltFlatSpot is positive, a flat spot is added to the curved section of the U-Bolt. This also reduces the bend radius and center points for the curved part of the U-Bolt.
IJUAhsJUBolt::IsJBolt
Specifies whether it is a J-Bolt or U-Bolt. It uses hsYesNo codelist. If IsJBolt is set to Yes, then the right side of the U-Bolt graphic below the tangent point is not drawn.