Liner Properties - Intergraph Smart 3D - Reference Data - Hexagon PPM

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
Hangers and Supports
Search by Category
Reference Data
Smart 3D Version
13.1

These properties define the geometry of the liner, which is an optional component. Values for these properties are necessary only when liner geometry is required.

IJUAhsThickness3::Thickness3 (Optional)

Specifies the thickness of the liner from the inside edge of the clevis hanger.

IJUAhsHeight8::Height8 (Optional)

Specifies the height from the pipe centerline to the top of the liner. This value is always less than Height5.

IJUAhsThickness4::Thickness4 (Optional)

Specifies the overall thickness if the liner is a wrap. If this value is less than or equal to Thickness3, then the software just draws a liner.