User Prompts - Intergraph Smart 3D - Reference Data - Hexagon PPM

Intergraph Smart 3D Hangers and Supports SmartParts Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
Hangers and Supports
Search by Category
Reference Data
Smart 3D Version
13.1

You can edit these properties on the part properties dialog box.

IJOAhsPipeOD::PipeOD

Specifies the actual outside diameter of the pipe (or insulation). By default, it is set to some reasonable value. Typically this value is passed in by the Assembly Information Rule (AIR). This value is used to position the strap vertically along with StrapTopGap.

IJOAhsPipeToSteel::PipeToSteel

Specifies the clearance between the outside of the pipe and the steel. By default, it is set to some reasonable value. Typically this value is passed in by the AIR.

IJOAhsSteelThickness::SteelThickness

Specifies the thickness of the steel to which the U-Bolt is attached. By default, it is set to some reasonable value. Typically this value is passed in by the AIR.

IJOAhsRoty::RotY

Rotates the strap along the Y-axis of the route port. Use this property to run the strap across the pipe and perpendicular to the pipe centerline.