These properties specify the end nut shape properties for the turnbuckle.
IJUAhsShape1::Shape1Type
Enter the codelist number of the shape type as defined in the hsShapeType sheet in the HS_S3DParts_Codelist.xls workbook.
In each of the following examples, the end nut shape is depicted with hatched lines.
-
1 - Round
-
2 - Square
-
3 - Hex
IJUAhsShape1::Shape1Width1
Specifies the outside dimension of the end nuts. If this value is set to zero, the end nut shape is not displayed.
-
1 - Round
-
2 - Square
-
3 - Hex
IJUAhsShape1::Shape1Width2
Specifies the outside length of the end nut shapes. If this value is set to zero, then the value specified in Shape1Width1 is used. This value is not used for Hex Shape.
-
1 - Round
-
2 - Square
IJUAhsShape1::Shape1Length
Specifies the thickness of the end nut shape. Both positive and negative values are acceptable. If this value is set to a negative, then the end nut shapes are located within Opening1. If this value is set to zero, then the end nut shape is not displayed.
-
Shape1Length < 0 (Negative)
-
Shape1Length > 0 (Positive)