Frame Output Value Properties - Intergraph Smart 3D - Reference Data - Hexagon PPM

Intergraph Smart 3D Hangers and Supports Data Driven Assembly

Language
English
Product
Intergraph Smart 3D
Subproduct
Hangers and Supports
Search by Category
Reference Data
Smart 3D Version
13

These properties are output dimensions populated by the AIR during placement.

The following properties are applicable for U, L, T, and Box Frame types.

IJUAhsFrameSpan::SpanValue

Specifies the span of the frame support. This property is set by the AIR and can be used for reporting purposes or for support validation.

IJUAhsFrameSpanDef::SpanDefinition

Defines where the span should be measured from. This property sets the definition of SpanValue.

Supported values are as follows for U-Frame and Box Frame are:

Supported values for the L-Frame type are as follows:

Supported values for the T-Frame type are as follows:

IJUAhsFrameLength1::Length1Value

Specifies the length of the first leg after the support has been placed. This property is set by the AIR and can be used for reporting purposes or for support validation.

IJUAhsFrameLength1Def::Length1Definition

Defines where the length should be measured from. This property sets the definition of Length1Value. Supported values are as follows:

For I-Frame:

  • 1 - End of Steel

  • 2 - End of Plate

  • 3 - Pipe Center Line

The following properties are applicable for U-Frame and Box Frame type only.

IJUAhsFrameLength2::Length2Value

Specifies the length of the second leg after the support has been placed. This property is set by the AIR and can be used for reporting purposes or for support validation.

IJUAhsFrameLength2Def::Length2Definition

Defines where the length should be measured from. This property sets the definition of Length2Value.

IJUAhsIsImpPart::IsImpPart

The software considers implied bold parts only if the IsImpPart is set to True and Bolt1Part, Bolt2Part, Bolt1Quantity, and Bolt2Quantity have some appropriate values.

  • If IsImpPart is set to True, the software does not display any bolt in the model but displays implied bolts in the work space explorer.

  • If IsImpPart is set to False, the software displays bolts both in the work space explorer and model.

  • If you do not assign valid values to Bolt1Part, Bolt2Part, Bolt1Quantity and Bolt2Quantity, the software does not display any bolt in the work space explorer or the model.