Strut1 Attributes - Intergraph Smart 3D - Reference Data

Intergraph Smart 3D Hangers and Supports Data Driven Assembly Configuration

Language
English
Product
Intergraph Smart 3D
Subproduct
3D Symbols
Search by Category
Reference Data
Smart 3D Version
11 (2016)

IJUAhsStrut_Strut1::Strut1ClassA

Specifies the part number or the part class of the strut A part.

IJUAhsStrut_Strut1::Strut1ClassB

Specifies the part number or the part class of the strut B part.

IJUAhsStrut1_Size1::Strut1Size1

Specifies the size of the strut A and B parts. This value is not used by the strut assembly, but it is required to use part selection rules to select the correct parts from the given part class.

IJUAhsStrut1_Size2::Strut1Size2

Specifies the size of the strut A and B parts. This value is not used by the strut assembly, but it is required to use part selection rules to select the correct parts from the given part class.

IJUAhsStrut1_Angle1::Strut1Angle1

Specifies the angle required on the pipe clamp. This property allows the pipe clamp to rotate around the pipe.

IJUAhsStrut1_Angle2::Strut1Angle2

Specifies the angle required on the strut. This property allows the strut to rotate along the pipe about the connection to the pipe clamp. The structure attachment remains attached to the steel, and the pipe clamp is moved along the pipe to put the strut at the specified angle.

IJUAhsStrut_Strut1::Strut1Offset1

Specifies the offset required in the strut. This property offsets the entire assembly along the pipe and is valid only when the support is placed using Place by Point command.

IJUAhsStrut_Strut1::Strut1MinP_P

Specifies the minimum pin to pin distance for a specific strut assembly. This value is not used by the strut assembly, but is required if you want to use part selection rules to select the correct parts from the given part class.

IJUAhsStrut_Strut1::Strut1EndOrientation

Specifies how the structural attachment on the end of the strut is orientated. Rotation is in reference to the structure object.

The allowed values from the Codelist hsStrutEndOrientation are as follows:

  • 1- Free Rotation

  • 2 - Parallel Orientation

  • 3 - Perpendicular Orientation

IJUAhsStrut_Strut1::Strut1Config

Specifies how Strut1Angle1 should be interpreted. The allowed values from the codelist hsStrutConfig are as follows:

  • 1 - Angle from Structure

  • 2 - Angle from Vertical