Get Features - Intergraph Smart 3D - Help - Hexagon

Intergraph Smart 3D HVAC

Language
English
Product
Intergraph Smart 3D
Subproduct
HVAC
Search by Category
Help
Smart 3D Version
13.1

If you have the Locate Filter set to Duct Parts, then Get Features selects the parent feature of the selected part or parts.

If you have the Locate Filter set to Duct Runs, then Get Features selects all the features in the selected run.

If you have the Locate Filter set to Duct Features, then Get Features contains a group of subcommands to select a targeted route network. The Get Features commands apply to features that are in the select set and are defined in the workspace. You can select one or more features on the network. You can also combine the following subcommands to extend the targeted network as necessary.

On Same Run

Selects all features that belong to a same run even if the run is discontinuous.

On Same Leg

Selects all features that belong to a same leg. The software also includes the along leg feature if the selected leg is a branch.

A leg is a group of route features routed in the same direction.

On All Connected Branches

Selects all features associated to the connected branches. You must select an along-leg feature that has a branch connected to it. For example, select an along-leg feature that has a branch connected to it. Right-click and select On All Connected Branches. The software selects the associated features connected to the branch run until it branches into a header run, or until a free end is traversed.

For Connected Fittings

Adds the immediate connected fittings to the selection. You must select a branch component.

SHARED Tip You can select a leg using On Same Leg, and then use For Connected Fittings to add all the adjacent branch fittings on that leg to the selection.