Show Control Points - Intergraph Smart 3D - Administration

Intergraph Smart 3D Geometry Analysis and Repair

Language
English
Product
Intergraph Smart 3D
Subproduct
Geometry Analysis and Repair
Search by Category
Administration & Configuration
Smart 3D Version
12.1 (2019)

Displays the control points and the control point mesh in the graphic view. This command is helpful when you want to see if the control point meshes are aligned. You can access this command by right-clicking an object when no other command is active.

The following picture shows control points and a control point mesh on a hull.

These control points are not the same as the control points in the Common task.