-
Click Select on the vertical toolbar.
-
In the Locate Filter, select Conduit Features.
-
Select a feature on the conduit section to move.
-
Right-click the feature, and select an option under Route Selection Commands > Get Features.
-
Click Move on the main ribbon.
If you move the conduit end within ¼ inch (6.35 mm) of another conduit run end, the software automatically connects the two ends.
-
Select a move-from point.
-
Identify the move-to point, and click the graphic view to move the conduit to the new location.
See Moving at Boundary Connections for information on how the software performs the move operation.
Connect a Set of Conduit Features
-
Click Select on the vertical toolbar.
-
In the Locate Filter, select Conduit Features.
-
Select a feature in the conduit section to modify.
-
Right-click the feature, and select an option under Route Selection Commands > Get Features.
-
Click Move on the main ribbon.
-
Click an end feature in the selection.
-
Click an open end feature to connect the selection to another conduit inline. Alternatively, click a straight feature to connect the selection to another conduit at a branch point.
The software lengthens or shortens the conduit run length as needed to make the connection. See Connecting conduit runs using Move.