Determines the label position along the length of a linear object, such as a structural member. You can specify 0, 100, or any integer between 0 and 100 as the percentage position of the label along the object. For horizontal members, the leftmost point is 0. For vertical members, the bottommost point is 0.
-
The following graphic illustrates a label with Percentage Offset set to 20.
-
The following graphic illustrates a label with Percentage Offset set to 50.
-
The Absolute Along Linear Object (DwgLinearAbsPos) positioning module uses the Percentage Offset property.
-
The following options allow you to manually edit the .xml file:
-
Type 0 to place the label at the leftmost end of a horizontal member, or at the bottommost end of a vertical member.
-
Type 1 to place the label at the rightmost end of a horizontal member, or at the topmost end of a vertical member.
-
Type a value between 0 and 1 to place the label at an intermediate point.
-
-
Enclose any of the above values within the following .xml tags.
<percentageOffset>0.5
</percentageOffset>