Specifies the distance outside of the matchline at which you want the leader line to terminate. For example, if you specify that the leader offset is 4 cm, then the end of the leader line closest to the matchline will terminate exactly 4 cm before reaching the matchline.
1 - 0.04 m leader offset |
1 -0.055 m leader offset |
-
You must specify the distance as a non-negative paper value.
-
You can use either metric or imperial units for this measurement.
-
The Margin (DwgMarginLeaderControl) leader module uses the Leader Offset property.
-
To manually edit the .xml file, enclose the offset measurement within the following .xml tags.
<leaderOffset>0.0</leaderOffset>